Brother firmware update lost connection failed

BROTHER FIRMWARE UPDATE LOST CONNECTION FAILED HOW TO
BROTHER FIRMWARE UPDATE LOST CONNECTION FAILED MAC OS
BROTHER FIRMWARE UPDATE LOST CONNECTION FAILED SERIAL

BROTHER FIRMWARE UPDATE LOST CONNECTION FAILED HOW TO

Open-source tool stm32ld ( ) is used to upload firmware to the board.'Р”Р„re there instructions somewhere on how to do this? Otherwise it's like saying 'here's what you need to make the cake'.

BROTHER FIRMWARE UPDATE LOST CONNECTION FAILED MAC OS

'Starting from 2.42b7, its possible to upgrade firmware from GUI under Mac OS and Linux (and virtually, any other OS).

BROTHER FIRMWARE UPDATE LOST CONNECTION FAILED SERIAL

Just as a PS to this, is there any way of configuring the Bluetooth connection in the GUI, like setting the parity? I've just downloaded a simple serial terminal program called goSerial which allows you to specify all the parameters for the Bluetooth port, but obviously that's a separate bit of software to the Basecam GUI, and the settings on one don't affect the other.Р”Р„lternatively, can you use a serial terminal program to upload the firmware? Is that what the manual means when it mentions the stm32ld program? Should the 'flash' jumper always be on the board when upgrading the firmware? Or only when manually uploading new firmware and not when doing it automatically?

I should add that I'm using a DesireRC Basecam board which only has Bluetooth for connecting to it.

I'm puzzled why it's possible to upload the recovery firmware with no issue on the Mac, but not the normal firmware?Р”Р„ny help is much appreciated as this has become quite frustrating now. 'Р”В«ut I have no idea what to do with the stm32ld thing. Open-source tool stm32ld ( ) is used to upload firmware to the board. I'm now left with a board that doesn't function which is a step further back than I was earlier this afternoon when I only had corrupted profiles!Р”В¬an someone please shed some light on this issue? Perhaps a fix has been announced for flashing firmware from the Mac since this thread was last updated? I was able to flash the recovery firmware which at least leaves me with a board with a firmware of 0.00b0, but then when trying to update to 2.43b9 it keeps giving me an 'Error writing firmware: Timeout!' message. Whilst trying to re-upgrade the firmware, it failed and then on power-cycling the board it would no longer boot. However, on doing the latter I'm now absolutely stuck! I have been experiencing problems with corrupted profiles and was advised (by Garug РІР‚вЂњ ah who's also posted in this thread!) to erase the EEPROM (which didn't make a difference) and then re-flash the firmware. I'm also stuck in exactly the same position as TheMasterSii. I also cannot connect to the board, it always stays in connecting.Р”В«efore I have to send back the gimbal with expensive shipping costs and again wasting of time, does anyone have an idea what the problem could be and a solution? Nothing, except the red LED which is on at the board.

I have searched all kind of forums, changed the COM port, changed the USB cable, checked the cable connections on the board. Please, verify the boot mode configuration, reset your device then try again. No response from the target, the Boot loader can not be started. I always get the same error messageР”Р‡irmware Upgrading - Failed to upload: Error writing firmware: Flash tool execution failed (1)! I tried it with my Mac, with Win XP under Parallels Desktop and in addition with a Win 7 laptop. I received a brand new gimbal from a kickstarted project but when switching it on only the battery LEDs get on.

Brother firmware update lost connection failed